- Price per m²
- £60–£106
- Typical life
- 25–50 years
- Manufacturer guarantees
- 20-year material warranties are common
- Typical garage roof
- £1,450–£2,600
Isle of Anglesey at a glance
- Largest towns
- Holyhead
- Postcode areas
- LL
- Building control
- Isle of Anglesey County Council
- Neighbouring areas
- Gwynedd · Conwy · Denbighshire · Flintshire
- Guide price region
- Wales (−8% on West Midlands rates)
How much does an EPDM rubber roof cost in Isle of Anglesey?
Guide prices including VAT at Wales rates. The fixed price comes after a free survey for new and replacement roofs.
| Job | Guide price inc VAT |
|---|---|
| Single garage (18 m²), EPDM rubber | £1,450–£2,600 |
| Extension (20 m²), EPDM, new deck + insulation | £2,600–£4,500 |
| Porch or bay (4 m²), EPDM | £700–£1,150 |
Which flat roofs are common in Isle of Anglesey?
Flat roofs in Isle of Anglesey sit on newer estates where the first extension roofs are now being replaced, lock-up garage blocks on estates and bungalows with flat-roofed side extensions and dormers. Wales averages roughly 1,460 mm of rain a year, among the wettest in Britain, so we design for steady run-off: proper falls, clear outlets and upstands well above the finished roof. Approximate 1991–2020 regional averages based on Met Office data.
Building regulations in Wales
Welsh guidance is that most re-roofing needs building control approval, so it's worth checking whenever more than a quarter of a roof is replaced or repaired. Renovated roofs are upgraded to around 0.16 W/m²K where feasible, and new extension roofs are built to 0.13 W/m²K under the Welsh Approved Document L. In Isle of Anglesey the application goes to Isle of Anglesey County Council. More on the rules.
How long does an EPDM roof last, and what guarantees come with it?
A well-specified EPDM roof typically lasts 25 to 50 years, and one BBA assessment of an EPDM membrane puts its expected life at 35 years or more. Problems usually come from poorly bonded upstands, damaged trims or ponding, rather than the rubber itself.
Three separate documents can sit behind an EPDM roof:
- Manufacturer material guarantee: covers the membrane and, on some systems, the wider build-up. Many need registration and a specified build-up, so we register it for you where the system allows.
- Our written workmanship guarantee: given on every re-roof, with the length set out in your quote.
- Insurance-backed guarantee: an option worth asking about if you want cover that does not depend on the contractor still trading.
A BBA certificate is an assessment of the product, not a guarantee. Our guide to flat roof guarantees explains the differences, and the lifespan guide compares EPDM with the other systems.
How are the joins, edges and upstands made watertight on an EPDM roof?
They are bonded with contact adhesive and sealed with purpose-made EPDM tapes and pre-formed pieces, because the edges and details are where most rubber roof leaks start.
- Wall upstands: the rubber is turned up the wall, usually to about 150 mm above the finished roof, fully bonded, then finished with a termination bar or a cover flashing chased into the masonry.
- Corners: folded rather than cut where possible, or finished with pre-formed pieces.
- Joins: on roofs wider than one sheet, the laps are cleaned, primed and joined with splice tape, then rolled firmly.
- Pipes and vents: sealed with pre-formed pipe boots rather than relying on mastic.
- Edges and outlets: drip and kerb trims are fixed and the junction with the membrane is sealed with cover tape; outlets are bonded into the membrane at the lowest point.
We also check the falls before laying, because standing water around an outlet shortens the life of any detail. There is more on this in our pages on edges and drainage and rooflight upstands.
Which towns in Isle of Anglesey do we cover?
EPDM rubber roofing in Isle of Anglesey: questions
Which towns in Isle of Anglesey do you cover?
All of Isle of Anglesey. The main towns have their own pages below, and if yours isn't listed we still cover it: send your postcode and we'll confirm.
How much does an EPDM rubber roof cost in Isle of Anglesey?
£1,450–£2,600 for a typical 18 m² garage roof in EPDM, at Wales guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.
Which council handles building control for a flat roof in Isle of Anglesey?
It depends on where the roof is: in Isle of Anglesey that's Isle of Anglesey County Council. Welsh guidance is that most re-roofing needs building control approval, so it's worth checking whenever more than a quarter of a roof is replaced or repaired. We confirm which applies at the survey.
Can you walk on an EPDM roof?
Occasionally, for maintenance, yes, but EPDM is not designed as a regular walking surface. Where you need a route to plant or windows, walkway pads can be bonded on, or GRP may be a better fit.
Does an EPDM roof need maintenance?
Very little. Clear leaves from outlets and gutters, look over trims and upstands once or twice a year and after storms, and keep foot traffic to a minimum.
Can an EPDM roof be fitted in winter?
Yes, as long as the deck is dry. The adhesives are affected by cold and damp, so very cold or wet days can delay bonding, and the roof is kept temporarily weathertight between dry spells.
Everything about EPDM rubber roofing → · All flat roofing in Isle of Anglesey →