Bedlington at a glance
- Postcode districts
- NE22
- Population
- about 18,470 (GeoNames)
- Council area
- Northumberland County Council
- Building approval
- Northumberland County Council building control, or a registered building control approver
- Nearest main town
- Blyth, about 3 miles
- Guide price region
- North East (−7% on West Midlands rates)
Why choose EPDM rubber roofing in Bedlington?
Rubber is a sensible pick in Bedlington where a roof sits close to bedrooms or a kitchen and you would rather avoid hot works. It suits porches, bays and dormers too, where the small area means a single sheet can cover the whole roof with no joins at all.
In and around Bedlington, flat roofs are typically found on 1930s semis with flat-roofed garages and kitchen extensions, and on bungalows with flat-roofed side extensions and dormers. England averages roughly 870 mm of rain a year; the North East is drier than the west but cold and windy near the coast, so wind uplift and freeze-thaw are in the specification.
How much does an EPDM rubber roof cost in Bedlington?
For Bedlington we use North East rates: £1,500–£2,600 is the guide for a typical 18 m² garage roof in EPDM, VAT included. The fixed price comes after a free survey for new and replacement roofs.
| Job | Guide price inc VAT |
|---|---|
| Single garage (18 m²), EPDM rubber | £1,500–£2,600 |
| Extension (20 m²), EPDM, new deck + insulation | £2,600–£4,550 |
| Porch or bay (4 m²), EPDM | £700–£1,150 |
Do I need building regulations approval to replace a roof with EPDM?
Often, yes. In England, Wales and Northern Ireland, re-covering more than half of a flat roof over a heated room usually counts as renovating a thermal element, so the roof should be insulated towards the renovation standard where that is feasible; in Scotland, the council's building standards service decides whether a building warrant is needed.
An unheated detached garage normally falls outside these rules, and a patch repair is treated differently from a full re-cover.
In practice that means a warm roof: insulation above the deck, a vapour control layer beneath it and the EPDM on top. The extra thickness lifts the finished roof, so at survey we check door thresholds, window cills, wall flashings and upstand heights, aiming for an upstand of about 150 mm above the finished surface. Where approval is needed, we deal with building control or building standards for you. The building regulations page and our warm vs cold roof guide go into more detail.
What's included?
- Deck check and replacement of soft or rotten boards
- New drip and kerb trims, outlets and upstand details
- Strip-out of the old covering, with waste taken away
- Warm-roof insulation and vapour control layer where required
Building regulations in England
Replacing more than half of a flat roof over a heated room usually counts as renovating a thermal element, so the roof is insulated to around 0.16 W/m²K where that's technically and economically feasible, and the work is notified to building control: the council or a registered building control approver, unless a registered competent person self-certifies it. A roof on a new extension is built to 0.15 W/m²K. Patch repairs, and most unheated detached garages, don't trigger the upgrade. Structural changes, or a new covering that adds 15% or more to the roof's weight, also need approval. More on the rules.
Which nearby areas do we also cover?
EPDM rubber roofing in Bedlington: questions
Do you cover Bedlington?
Yes. Bedlington is part of our Northumberland coverage, including postcode districts NE22. Surveys and roofs are carried out by vetted roofing teams working under S&K Property Investments and Improvement Ltd.
Who checks building regulations for a flat roof in Bedlington?
Where the work needs approval it goes to Northumberland County Council building control, or a registered building control approver. We tell you at the survey whether your job needs it and deal with the paperwork as part of the quote.
How much does an EPDM rubber roof cost in Bedlington?
£1,500–£2,600 for a typical 18 m² garage roof in EPDM, at North East guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.
Can you put a green roof on top of EPDM?
Yes. EPDM is often used under sedum, with a protection layer, drainage and growing medium laid on top. The structure must be able to carry the extra weight, which we check before quoting.
Can a punctured EPDM roof be repaired?
Usually, yes. The area is cleaned and primed, then an EPDM patch or cover tape is bonded over the damage. If water has reached the deck, a survey first is sensible.