Flat RoofingContractors

Flat roof systems

EPDM rubber roofing across Swansea

We fit EPDM rubber roofing across Swansea, on everything from single garages to insulated extension roofs and dormers. Each job begins with a free survey and ends with a written workmanship guarantee. Prices on this page are guide figures for the region; your fixed price comes in writing once a surveyor has checked the deck, falls, upstands and access.

Roofer unrolling a single sheet of black EPDM membrane over a new OSB deck on a garage roofComputer-generated example image
Price per m²
£60–£106
Typical life
25–50 years
Manufacturer guarantees
20-year material warranties are common
Typical garage roof
£1,450–£2,600

Swansea at a glance

Largest towns
Swansea, Gorseinon, Clydach
Postcode areas
SA
Building control
Swansea Council
Neighbouring areas
Neath Port Talbot · Carmarthenshire · Bridgend · Rhondda Cynon Taf
Guide price region
Wales (−8% on West Midlands rates)

How much does an EPDM rubber roof cost in Swansea?

Guide prices including VAT at Wales rates. The fixed price comes after a free survey for new and replacement roofs.

JobGuide price inc VAT
Single garage (18 m²), EPDM rubber£1,450–£2,600
Extension (20 m²), EPDM, new deck + insulation£2,600–£4,500
Porch or bay (4 m²), EPDM£700–£1,150

Which flat roofs are common in Swansea?

Flat roofs in Swansea sit on lock-up garage blocks on estates, low-rise post-war blocks of flats and shops with flat-roofed rear stores below flats. Wales averages roughly 1,460 mm of rain a year, among the wettest in Britain, so we design for steady run-off: proper falls, clear outlets and upstands well above the finished roof. Approximate 1991–2020 regional averages based on Met Office data.

Building regulations in Wales

Welsh guidance is that most re-roofing needs building control approval, so it's worth checking whenever more than a quarter of a roof is replaced or repaired. Renovated roofs are upgraded to around 0.16 W/m²K where feasible, and new extension roofs are built to 0.13 W/m²K under the Welsh Approved Document L. In Swansea the application goes to Swansea Council. More on the rules.

How long does an EPDM roof last, and what guarantees come with it?

A well-specified EPDM roof typically lasts 25 to 50 years, and one BBA assessment of an EPDM membrane puts its expected life at 35 years or more. Problems usually come from poorly bonded upstands, damaged trims or ponding, rather than the rubber itself.

Three separate documents can sit behind an EPDM roof:

  • Manufacturer material guarantee: covers the membrane and, on some systems, the wider build-up. Many need registration and a specified build-up, so we register it for you where the system allows.
  • Our written workmanship guarantee: given on every re-roof, with the length set out in your quote.
  • Insurance-backed guarantee: an option worth asking about if you want cover that does not depend on the contractor still trading.

A BBA certificate is an assessment of the product, not a guarantee. Our guide to flat roof guarantees explains the differences, and the lifespan guide compares EPDM with the other systems.

How are the joins, edges and upstands made watertight on an EPDM roof?

They are bonded with contact adhesive and sealed with purpose-made EPDM tapes and pre-formed pieces, because the edges and details are where most rubber roof leaks start.

  • Wall upstands: the rubber is turned up the wall, usually to about 150 mm above the finished roof, fully bonded, then finished with a termination bar or a cover flashing chased into the masonry.
  • Corners: folded rather than cut where possible, or finished with pre-formed pieces.
  • Joins: on roofs wider than one sheet, the laps are cleaned, primed and joined with splice tape, then rolled firmly.
  • Pipes and vents: sealed with pre-formed pipe boots rather than relying on mastic.
  • Edges and outlets: drip and kerb trims are fixed and the junction with the membrane is sealed with cover tape; outlets are bonded into the membrane at the lowest point.

We also check the falls before laying, because standing water around an outlet shortens the life of any detail. There is more on this in our pages on edges and drainage and rooflight upstands.

Which towns in Swansea do we cover?

EPDM rubber roofing in Swansea: questions

Which towns in Swansea do you cover?

All of Swansea. The main towns have their own pages below, and if yours isn't listed we still cover it: send your postcode and we'll confirm.

How much does an EPDM rubber roof cost in Swansea?

£1,450–£2,600 for a typical 18 m² garage roof in EPDM, at Wales guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.

Which postcode areas do you cover in Swansea?

All of Swansea, including the SA postcode areas. Send your full postcode and we'll confirm.

Can a punctured EPDM roof be repaired?

Usually, yes. The area is cleaned and primed, then an EPDM patch or cover tape is bonded over the damage. If water has reached the deck, a survey first is sensible.

Can an EPDM roof be fitted in winter?

Yes, as long as the deck is dry. The adhesives are affected by cold and damp, so very cold or wet days can delay bonding, and the roof is kept temporarily weathertight between dry spells.

Can you walk on an EPDM roof?

Occasionally, for maintenance, yes, but EPDM is not designed as a regular walking surface. Where you need a route to plant or windows, walkway pads can be bonded on, or GRP may be a better fit.

Everything about EPDM rubber roofing → · All flat roofing in Swansea →

Get a fixed price for your flat roof

Free survey and a written fixed quote for replacement and new roofs. No obligation.

Call usGet a guide price