Flat roof surveys and leak tracing across Berkshire

Guide price

£170–£330

Repair price

Confirmed once the leak or damage is found

Condition survey report

£170–£330

Coverage

England, Wales, Scotland, NI

How much does a flat roof survey cost in Berkshire?

Guide prices including VAT at South East rates. We confirm the price once we've traced the leak or seen the damage.

Which flat roofs are common in Berkshire?

Flat roofs in Berkshire sit on 1930s semis with flat-roofed garages and kitchen extensions, lock-up garage blocks on estates and shops with flat-roofed rear stores below flats. Much of the South East sits in the drier Thames catchment at roughly 730 mm of rain a year, so the usual failures are at joints, upstands and outlets rather than from sheer volume of rain. Approximate 1991–2020 regional averages based on Met Office data.

Building regulations in England

Replacing more than half of a roof over a heated room usually counts as renovating a thermal element, so it is insulated to current standards and notified to building control. Renovated roofs over heated rooms are insulated to around 0.16 W/m²K where that's feasible, and new extension roofs are built to 0.15 W/m²K. In Berkshire the application goes to Reading Borough Council, Slough Borough Council, Bracknell Forest Council and 3 other councils. More on the rules.

How long does a flat roof survey take and how long is it valid?

A survey of a typical garage or extension roof usually takes an hour or two on site. Larger, higher or multi-area roofs take longer, and the written report follows afterwards.

A survey describes the roof on the day it was inspected. It stays a useful baseline for planning, but roofs change, particularly older ones and after a hard winter or a storm. If you are using a report to plan a replacement some time later, or after a fresh leak, a short follow-up check is sensible. For roofs you manage over the long term, a regular inspection backed by the maintenance checklist picks up problems early.

How do you find where a flat roof is leaking?

By working from the evidence inside back to the likely entry points outside, then confirming the path with moisture readings and, where needed, small test openings.

We start indoors, looking at where the staining is, when it appears and whether it follows rain, wind from one direction or cold weather. Then, on the roof, we check the details where most leaks start: upstands and flashings, laps and seams, outlets, gutters, edge trims, rooflight kerbs and anything that passes through the covering. Walls, copings and cavity trays above the roof are checked too, because water getting in behind an upstand can look like a roof leak.

A moisture meter shows where the covering, or the material beneath it, is holding water, and readings across the roof help map how far the wet has spread. Meter readings are a guide, not proof, so where they suggest a problem we may take a core sample: a small cut through the covering and insulation to see what is underneath and whether the deck is sound. The opening is sealed again with compatible material before we leave.

Condensation can also look like a leak, especially in older cold roofs without adequate ventilation, and the survey considers that possibility too. The flat roof leaks guide explains the common causes.

Which towns in Berkshire do we cover?

• Reading
• Slough
• Bracknell
• Maidenhead
• Wokingham
• Newbury
• Lower Earley
• Windsor
• Crowthorne
• Thatcham
• Sandhurst
• Ascot

Everything about flat roof surveys and leak tracing → · All flat roofing in Berkshire →