Flat RoofingContractors

Repairs and surveys

Flat roof surveys and leak tracing in Slough

Flat roof surveys in Slough cover garages, extensions, dormers, balconies and commercial roofs. You get a plain written report on the covering, upstands, edges, falls and drainage, with clear recommendations and guide costs, so you can make a decision on the evidence.

Moisture meter being used on a flat roof membrane during a condition surveyComputer-generated example image

Slough at a glance

Postcode districts
SL1, SL2, SL3
Population
about 164,793 (GeoNames)
Council area
Slough Borough Council
Building approval
Slough Borough Council building control, or a registered building control approver
Nearest main town
Reading, about 17 miles
Guide price region
South East (+10% on West Midlands rates)

When is a flat roof survey worth it in Slough?

Landlords and managing agents in Slough often need a written record of a roof's condition, for budgeting, for leaseholders, or to show a problem has been looked at properly. A survey report gives them a clear basis for deciding when to repair and when to replace.

In and around Slough, flat roofs are typically found on shops with flat-roofed rear stores below flats, and on 1930s semis with flat-roofed garages and kitchen extensions. Much of the South East sits in the drier Thames catchment at roughly 730 mm of rain a year, so the usual failures are at joints, upstands and outlets rather than from sheer volume of rain.

How much does a flat roof survey cost in Slough?

At South East guide rates, a condition survey and leak investigation comes to £170–£330 including VAT. We confirm the price once we've traced the leak or seen the damage.

JobGuide price inc VAT
Condition survey and leak investigation£170–£330
Localised patch repair£170–£550
Upstand or flashing repair£280–£720
Emergency temporary weatherproofing visit£200–£500

How do you find where a flat roof is leaking?

By working from the evidence inside back to the likely entry points outside, then confirming the path with moisture readings and, where needed, small test openings.

We start indoors, looking at where the staining is, when it appears and whether it follows rain, wind from one direction or cold weather. Then, on the roof, we check the details where most leaks start: upstands and flashings, laps and seams, outlets, gutters, edge trims, rooflight kerbs and anything that passes through the covering. Walls, copings and cavity trays above the roof are checked too, because water getting in behind an upstand can look like a roof leak.

A moisture meter shows where the covering, or the material beneath it, is holding water, and readings across the roof help map how far the wet has spread. Meter readings are a guide, not proof, so where they suggest a problem we may take a core sample: a small cut through the covering and insulation to see what is underneath and whether the deck is sound. The opening is sealed again with compatible material before we leave.

Condensation can also look like a leak, especially in older cold roofs without adequate ventilation, and the survey considers that possibility too. The flat roof leaks guide explains the common causes.

What's included?

  • Inspection of the covering, upstands, edges and outlets
  • Free quote if replacement is the right answer
  • Plain written report with ranked recommendations
  • Checks on walls, copings and trays above the roof

Building regulations in England

Replacing more than half of a flat roof over a heated room usually counts as renovating a thermal element, so the roof is insulated to around 0.16 W/m²K where that's technically and economically feasible, and the work is notified to building control: the council or a registered building control approver, unless a registered competent person self-certifies it. A roof on a new extension is built to 0.15 W/m²K. Patch repairs, and most unheated detached garages, don't trigger the upgrade. Structural changes, or a new covering that adds 15% or more to the roof's weight, also need approval. More on the rules.

Which nearby areas do we also cover?

Flat roof surveys and leak tracing in Slough: questions

Do you cover Slough?

Yes. Slough is part of our Berkshire coverage, including postcode districts SL1, SL2, SL3. Surveys and roofs are carried out by vetted roofing teams working under S&K Property Investments and Improvement Ltd.

Who checks building regulations for a flat roof in Slough?

Where the work needs approval it goes to Slough Borough Council building control, or a registered building control approver. We tell you at the survey whether your job needs it and deal with the paperwork as part of the quote.

How much does a flat roof survey cost in Slough?

£170–£330 for a condition survey and leak investigation, at South East guide rates including VAT. We confirm the price once we've traced the leak or seen the damage.

Can you trace a flat roof leak without opening the roof up?

Often, yes. Careful inspection and moisture readings can usually locate the problem area. Where they can't, a small core sample is the most reliable way to confirm what is happening under the covering.

Do you survey commercial and block roofs?

Yes. We survey flat roofs on shops, offices, units, blocks of flats and HMOs, with the report structured so a landlord, managing agent or owner can plan and budget the work.

Other flat roof work in Slough

Flat roof surveys and leak tracing in Slough: get a fixed price

Free survey and a written fixed quote for replacement and new roofs. No obligation.

Call usGet a guide price