Burry Port at a glance
- Postcode districts
- SA16
- Population
- about 8,310 (GeoNames)
- Council area
- Carmarthenshire County Council
- Building approval
- Carmarthenshire County Council building control, or a registered building control approver
- Nearest main town
- Llanelli, about 4 miles
- Guide price region
- Wales (−8% on West Midlands rates)
What do block and HMO roofs in Burry Port need?
Leaseholders in Burry Port want to see where their money goes. Our itemised quotes show each element of the job separately, including scaffold, insulation and provisional sums for hidden defects, which makes them easier to share and compare when the freeholder or agent is consulting on the work.
In a town like Burry Port, flat roofs are commonly found on 1930s semis with flat-roofed garages and kitchen extensions or newer estates where the first extension roofs are now being replaced. Wales averages roughly 1,460 mm of rain a year, among the wettest in Britain, so we design for steady run-off: proper falls, clear outlets and upstands well above the finished roof.
How much does a block or HMO roof cost in Burry Port?
For Burry Port we use Wales rates: £14,300–£25,000 is the guide for a 150 m² block-of-flats roof in felt with insulation and scaffold, VAT included. The fixed price comes after a free survey for new and replacement roofs.
| Job | Guide price inc VAT |
|---|---|
| Block of flats (150 m²), felt + insulation + scaffold | £14,300–£25,000 |
| Commercial roof (100 m²), single-ply + insulation | £12,150–£20,050 |
How does Section 20 consultation affect roof works?
In England and Wales, if leaseholders pay for roof works through the service charge and any one leaseholder's share will be over the statutory threshold, the freeholder or managing agent must consult them under Section 20 of the Landlord and Tenant Act 1985 before the work is contracted.
The consultation is run by the freeholder or agent, not by us. It usually involves a notice of intention and then estimates shared with leaseholders, each stage with time for comments, and missing a step can limit what can be recovered through the service charge. Take advice from your agent or a specialist adviser if you are unsure; we don't give legal advice.
What we provide is an itemised written quote that is easy to share and compare: system and build-up, roof area, scaffold and access, insulation, outlets, upstands and trims, waste disposal, provisional sums for hidden defects such as deck repairs, and VAT shown clearly. We can price more than one system on the same scope, so leaseholders are comparing like with like.
What's included?
- Long-life systems: mastic asphalt, EPDM, single-ply and built-up felt
- Building control and insulation upgrades handled where needed
- Resident notices, access planning and phased work
- Free survey and fixed, itemised written quote
Building regulations in Wales
The Welsh Approved Document L applies. Renovating more than half of a roof over a heated room means upgrading it to around 0.16 W/m²K where feasible, and new extension roofs are built to 0.13 W/m²K. Welsh Government guidance is that most re-roofing needs building control approval, so check whenever more than a quarter of a roof is replaced or repaired. We deal with the application as part of the job. More on the rules.
Which nearby areas do we also cover?
Flats, HMOs and block roofs in Burry Port: questions
Do you cover Burry Port?
Yes. Burry Port is part of our Carmarthenshire coverage, including postcode districts SA16. Surveys and roofs are carried out by vetted roofing teams working under S&K Property Investments and Improvement Ltd.
Who checks building regulations for a flat roof in Burry Port?
Where the work needs approval it goes to Carmarthenshire County Council building control, or a registered building control approver. We tell you at the survey whether your job needs it and deal with the paperwork as part of the quote.
How much does a block or HMO roof cost in Burry Port?
£14,300–£25,000 for a 150 m² block-of-flats roof in felt with insulation and scaffold, at Wales guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.
Can a block roof be replaced in phases?
Yes. Larger roofs can be split into sections over one or more budget years, with each phase priced separately and each section left watertight before the team leaves site.
Does a block roof replacement need building control?
Usually, yes. Re-covering more than half of a roof over heated flats normally triggers the thermal element rules, which bring insulation and approval requirements, and we handle building control or building standards where it is needed.