- Guide price
- £17,100–£29,900
- Survey
- Free for new and replacement roofs
- Quote
- Fixed, in writing
- Coverage
- England, Wales, Scotland, NI
Kent at a glance
- Largest towns
- Maidstone, Gillingham, Royal Tunbridge Wells, Folkestone
- Postcode areas
- BR, CT, DA, ME, TN
- Building control
- Maidstone Borough Council, Medway Council, Tunbridge Wells Borough Council and 10 other councils
- Neighbouring areas
- Essex · London · East Sussex · Surrey
- Guide price region
- South East (+10% on West Midlands rates)
How much does a block or HMO roof cost in Kent?
Guide prices including VAT at South East rates. The fixed price comes after a free survey for new and replacement roofs.
| Job | Guide price inc VAT |
|---|---|
| Block of flats (150 m²), felt + insulation + scaffold | £17,100–£29,900 |
| Commercial roof (100 m²), single-ply + insulation | £14,550–£23,950 |
Which flat roofs are common in Kent?
Flat roofs in Kent sit on shops with flat-roofed rear stores below flats, 1930s semis with flat-roofed garages and kitchen extensions and lock-up garage blocks on estates. Much of the South East sits in the drier Thames catchment at roughly 730 mm of rain a year, so the usual failures are at joints, upstands and outlets rather than from sheer volume of rain. Approximate 1991–2020 regional averages based on Met Office data.
Building regulations in England
Replacing more than half of a roof over a heated room usually counts as renovating a thermal element, so it is insulated to current standards and notified to building control. Renovated roofs over heated rooms are insulated to around 0.16 W/m²K where that's feasible, and new extension roofs are built to 0.15 W/m²K. In Kent the application goes to Maidstone Borough Council, Medway Council, Tunbridge Wells Borough Council and 10 other councils. More on the rules.
How does Section 20 consultation affect roof works?
In England and Wales, if leaseholders pay for roof works through the service charge and any one leaseholder's share will be over the statutory threshold, the freeholder or managing agent must consult them under Section 20 of the Landlord and Tenant Act 1985 before the work is contracted.
The consultation is run by the freeholder or agent, not by us. It usually involves a notice of intention and then estimates shared with leaseholders, each stage with time for comments, and missing a step can limit what can be recovered through the service charge. Take advice from your agent or a specialist adviser if you are unsure; we don't give legal advice.
What we provide is an itemised written quote that is easy to share and compare: system and build-up, roof area, scaffold and access, insulation, outlets, upstands and trims, waste disposal, provisional sums for hidden defects such as deck repairs, and VAT shown clearly. We can price more than one system on the same scope, so leaseholders are comparing like with like.
Do fire and insulation rules affect block roofs?
Yes. Where a roof is close to a boundary, building regulations limit which coverings can be used, and the build-up should carry a suitable external fire classification such as BROOF(t4); in England this is covered by Approved Document B.
BROOF(t4) applies to a tested build-up, so we check that the manufacturer's classification covers the deck, insulation and membrane actually being installed, not just the membrane name. Where the roof crosses a separating or compartment wall, the fire-stopping detail is kept intact.
Re-covering more than half of a roof over heated flats usually triggers the thermal element rules, so the insulation is upgraded towards the renovation U-value where feasible: 0.16 W/m²K for dwellings in England and Wales. We handle building control where it is needed. See building regulations and warm vs cold roofs.
Which towns in Kent do we cover?
- Maidstone
- Gillingham
- Royal Tunbridge Wells
- Folkestone
- Margate
- Ashford
- Canterbury
- Sittingbourne
- Gravesend
- Dartford
- Ramsgate
- Dover
- Tonbridge
- Strood
- Whitstable
- Deal
- Sevenoaks
- Herne Bay
- Broadstairs
- Faversham
- Swanley
- Longfield
- Swanscombe
Flats, HMOs and block roofs in Kent: questions
Which towns in Kent do you cover?
All of Kent. The main towns have their own pages below, and if yours isn't listed we still cover it: send your postcode and we'll confirm.
How much does a block or HMO roof cost in Kent?
£17,100–£29,900 for a 150 m² block-of-flats roof in felt with insulation and scaffold, at South East guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.
Which council handles building control for a flat roof in Kent?
It depends on where the roof is: in Kent that's Maidstone Borough Council, Medway Council, Tunbridge Wells Borough Council and 10 other councils. Replacing more than half of a roof over a heated room usually counts as renovating a thermal element, so it is insulated to current standards and notified to building control. We confirm which applies at the survey.
Does a block roof replacement need building control?
Usually, yes. Re-covering more than half of a roof over heated flats normally triggers the thermal element rules, which bring insulation and approval requirements, and we handle building control or building standards where it is needed.
Do you work for HMO landlords?
Yes. We replace and repair flat roofs on HMOs and converted flats, arrange access with tenants through the landlord or agent, and keep escape routes and entrances clear while we work.
What if a top-floor flat is leaking before the roof is replaced?
We can attend for emergency temporary weatherproofing as soon as a team is available, guide £200–£500. That protects the flat while the permanent work is agreed.
Everything about flats, HMOs and block roofs → · All flat roofing in Kent →