Flat RoofingContractors

Flat roof systems

Liquid-applied roofing in Mold

Liquid membranes give Mold property owners a jointless, cold-applied roof without laps or separate flashings. They are especially useful around pipes, rooflights and tight corners where sheet systems need lots of cutting. If the roof below is wet or rotten, we say so and quote for the right fix instead.

Grey liquid waterproofing and reinforcement fleece rolled around a vent pipe on a flat roofComputer-generated example image

Mold at a glance

Postcode districts
CH7
Population
about 10,058 (GeoNames)
Council area
Flintshire County Council
Building approval
Flintshire County Council building control, or a registered building control approver
Nearest main town
Buckley, about 2 miles
Guide price region
Wales (−8% on West Midlands rates)

Why choose a liquid-applied roof in Mold?

Liquid roofing suits a roof in Mold that is full of penetrations, such as soil pipes, vents, aerial brackets and rooflights, because the liquid flows around each one and cures into a single skin. There are no cut pieces or taped corners to work loose over time.

In a town like Mold, flat roofs are commonly found on newer estates where the first extension roofs are now being replaced or 1960s and 1970s link-detached houses with flat-roofed garages and porches. Wales averages roughly 1,460 mm of rain a year, among the wettest in Britain, so we design for steady run-off: proper falls, clear outlets and upstands well above the finished roof.

How much does a liquid-applied roof cost in Mold?

At Wales guide rates, a typical 18 m² garage roof in a liquid-applied system comes to £1,900–£3,000 including VAT. The fixed price comes after a free survey for new and replacement roofs.

JobGuide price inc VAT
Single garage (18 m²), liquid-applied£1,900–£3,000
Balcony (12 m²), liquid-applied, scaffold£1,750–£3,000
Single garage (18 m²), EPDM rubber£1,450–£2,600
Extension (20 m²), EPDM, new deck + insulation£2,600–£4,500

Can a liquid roof go over my existing roof, and what preparation is needed?

Yes, if the existing roof is dry, firmly bonded and sitting on a sound deck. A liquid membrane is only as good as what lies beneath it, so we test the old roof before agreeing to overlay it.

At survey we check for:

  • Trapped moisture: soft spots, blisters or wet insulation mean the roof should be stripped, because water sealed in will cause new blisters and decay.
  • Deck condition: any sponginess or deflection needs repair first.
  • Adhesion: on felt and asphalt, loose areas are cut out and patched, and the existing surface must take the primer properly.
  • Falls and ponding: a coating follows the roof as it is. If water ponds now, it will pond on the new surface too unless the falls are corrected.

Preparation then follows: loose chippings removed, the surface cleaned and left to dry, blisters cut back and repaired, cracks filled, and the right primer applied. On older felt, mineral surfaces may need extra cleaning to give a good bond. Where the tests fail, we say so plainly and quote for a strip and re-roof. Read more on ponding water.

What's included?

  • Survey of the existing roof, including moisture and adhesion checks
  • Fleece-reinforced liquid membrane applied to the specified thickness
  • Primer matched to the substrate
  • Surface cleaning, repairs and removal of loose material

Building regulations in Wales

The Welsh Approved Document L applies. Renovating more than half of a roof over a heated room means upgrading it to around 0.16 W/m²K where feasible, and new extension roofs are built to 0.13 W/m²K. Welsh Government guidance is that most re-roofing needs building control approval, so check whenever more than a quarter of a roof is replaced or repaired. We deal with the application as part of the job. More on the rules.

Which nearby areas do we also cover?

Liquid-applied roofing in Mold: questions

Do you cover Mold?

Yes. Mold is part of our Flintshire coverage, including postcode districts CH7. Surveys and roofs are carried out by vetted roofing teams working under S&K Property Investments and Improvement Ltd.

Who checks building regulations for a flat roof in Mold?

Where the work needs approval it goes to Flintshire County Council building control, or a registered building control approver. We tell you at the survey whether your job needs it and deal with the paperwork as part of the quote.

How much does a liquid-applied roof cost in Mold?

£1,900–£3,000 for a typical 18 m² garage roof in a liquid-applied system, at Wales guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.

What is a fleece-reinforced liquid roof?

It is a liquid membrane with a polyester fleece embedded between coats. The fleece adds strength, helps control thickness and resists cracking where the surface moves slightly.

Is liquid roofing good for balconies?

Often, yes. It forms neatly around railings, door thresholds and drains, and some systems take foot traffic. A new balcony or roof terrace generally needs planning permission, so check before converting a roof.

Other flat roof work in Mold

Liquid-applied roofing in Mold: get a fixed price

Free survey and a written fixed quote for replacement and new roofs. No obligation.

Call usGet a guide price