Flat RoofingContractors

Flat roof systems

Liquid-applied roofing in Dover

Have a flat roof in Dover with awkward details, a balcony that leaks at the threshold, or an old covering that is still dry underneath? A liquid membrane may suit. We survey free of charge, name the system and thickness in a fixed quote, and register the manufacturer guarantee where the system allows.

Grey liquid waterproofing and reinforcement fleece rolled around a vent pipe on a flat roofComputer-generated example image

Dover at a glance

Postcode districts
CT14, CT16, CT17
Population
about 41,709 (GeoNames)
Council area
Dover District Council
Building approval
Dover District Council building control, or a registered building control approver
Guide price region
South East (+10% on West Midlands rates)

Why choose a liquid-applied roof in Dover?

Where a building in Dover has an older asphalt or concrete roof that is sound but tiring, a compatible liquid system can sometimes refresh it. The key is matching the primer and system to the substrate and dealing with any blisters, cracks or poor falls before the membrane goes on.

Dover's flat roofs are mostly on shops with flat-roofed rear stores below flats, with plenty on terraced streets with flat-roofed rear kitchens and bathrooms too. Much of the South East sits in the drier Thames catchment at roughly 730 mm of rain a year, so the usual failures are at joints, upstands and outlets rather than from sheer volume of rain.

How much does a liquid-applied roof cost in Dover?

At South East guide rates, a typical 18 m² garage roof in a liquid-applied system comes to £2,250–£3,600 including VAT. The fixed price comes after a free survey for new and replacement roofs.

JobGuide price inc VAT
Single garage (18 m²), liquid-applied£2,250–£3,600
Balcony (12 m²), liquid-applied, scaffold£2,100–£3,600
Single garage (18 m²), EPDM rubber£1,750–£3,100
Extension (20 m²), EPDM, new deck + insulation£3,100–£5,350

Can a liquid roof go over my existing roof, and what preparation is needed?

Yes, if the existing roof is dry, firmly bonded and sitting on a sound deck. A liquid membrane is only as good as what lies beneath it, so we test the old roof before agreeing to overlay it.

At survey we check for:

  • Trapped moisture: soft spots, blisters or wet insulation mean the roof should be stripped, because water sealed in will cause new blisters and decay.
  • Deck condition: any sponginess or deflection needs repair first.
  • Adhesion: on felt and asphalt, loose areas are cut out and patched, and the existing surface must take the primer properly.
  • Falls and ponding: a coating follows the roof as it is. If water ponds now, it will pond on the new surface too unless the falls are corrected.

Preparation then follows: loose chippings removed, the surface cleaned and left to dry, blisters cut back and repaired, cracks filled, and the right primer applied. On older felt, mineral surfaces may need extra cleaning to give a good bond. Where the tests fail, we say so plainly and quote for a strip and re-roof. Read more on ponding water.

What's included?

  • Surface cleaning, repairs and removal of loose material
  • Fleece-reinforced liquid membrane applied to the specified thickness
  • Survey of the existing roof, including moisture and adhesion checks
  • Primer matched to the substrate

Building regulations in England

Replacing more than half of a flat roof over a heated room usually counts as renovating a thermal element, so the roof is insulated to around 0.16 W/m²K where that's technically and economically feasible, and the work is notified to building control: the council or a registered building control approver, unless a registered competent person self-certifies it. A roof on a new extension is built to 0.15 W/m²K. Patch repairs, and most unheated detached garages, don't trigger the upgrade. Structural changes, or a new covering that adds 15% or more to the roof's weight, also need approval. More on the rules.

Which nearby areas do we also cover?

Liquid-applied roofing in Dover: questions

Do you cover Dover?

Yes. Dover is part of our Kent coverage, including postcode districts CT14, CT16, CT17. Surveys and roofs are carried out by vetted roofing teams working under S&K Property Investments and Improvement Ltd.

Who checks building regulations for a flat roof in Dover?

Where the work needs approval it goes to Dover District Council building control, or a registered building control approver. We tell you at the survey whether your job needs it and deal with the paperwork as part of the quote.

How much does a liquid-applied roof cost in Dover?

£2,250–£3,600 for a typical 18 m² garage roof in a liquid-applied system, at South East guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.

How long does a liquid roof take to cure?

That depends on the product and the weather. Some systems are rain-resistant within an hour or so, others take longer, and full cure can take a day or more in cool weather.

Is liquid roofing good for balconies?

Often, yes. It forms neatly around railings, door thresholds and drains, and some systems take foot traffic. A new balcony or roof terrace generally needs planning permission, so check before converting a roof.

Other flat roof work in Dover

Liquid-applied roofing in Dover: get a fixed price

Free survey and a written fixed quote for replacement and new roofs. No obligation.

Call usGet a guide price