Flat RoofingContractors

Flat roof systems

Single-ply membrane roofing across Berkshire

Across Berkshire, our vetted teams working under S&K replace tired flat roofs with PVC, TPO or FPO single-ply, laid over warm-roof or tapered insulation. Seams are hot-air welded and probed along their full length. Guide prices on this page reflect the region, and your own fixed price follows a free survey of the roof.

Light grey single-ply membrane roof with welded seams, outlets and plant on a commercial buildingComputer-generated example image
Price per m²
£99–£160
Typical life
25–35+ years
Manufacturer guarantees
20–25 year guarantees on specified systems
Typical garage roof
£2,250–£3,650

Berkshire at a glance

Largest towns
Reading, Slough, Bracknell, Maidenhead
Postcode areas
GU, RG, SL
Building control
Reading Borough Council, Slough Borough Council, Bracknell Forest Council and 3 other councils
Neighbouring areas
Surrey · Buckinghamshire · Hampshire · Oxfordshire
Guide price region
South East (+10% on West Midlands rates)

How much does a single-ply roof cost in Berkshire?

Guide prices including VAT at South East rates. The fixed price comes after a free survey for new and replacement roofs.

JobGuide price inc VAT
Commercial roof (100 m²), single-ply + insulation£14,550–£23,950
Single garage (18 m²), single-ply£2,250–£3,650
Single garage (18 m²), EPDM rubber£1,750–£3,100
Extension (20 m²), EPDM, new deck + insulation£3,100–£5,350

Which flat roofs are common in Berkshire?

Flat roofs in Berkshire sit on shops with flat-roofed rear stores below flats, 1960s and 1970s link-detached houses with flat-roofed garages and porches and low-rise post-war blocks of flats. Much of the South East sits in the drier Thames catchment at roughly 730 mm of rain a year, so the usual failures are at joints, upstands and outlets rather than from sheer volume of rain. Approximate 1991–2020 regional averages based on Met Office data.

Building regulations in England

Replacing more than half of a roof over a heated room usually counts as renovating a thermal element, so it is insulated to current standards and notified to building control. Renovated roofs over heated rooms are insulated to around 0.16 W/m²K where that's feasible, and new extension roofs are built to 0.15 W/m²K. In Berkshire the application goes to Reading Borough Council, Slough Borough Council, Bracknell Forest Council and 3 other councils. More on the rules.

How long does a single-ply roof last, and what guarantee comes with it?

A well-installed single-ply roof typically lasts 25 to 35 years or more. Its life depends mostly on the quality of the welds, the fixing pattern, protection from foot traffic and keeping outlets clear.

Signs of trouble on an older single-ply roof include seams lifting at the edges, shrinkage pulling at upstands and corners, punctures near plant, and loose fixings under the membrane on windy sites.

Manufacturer guarantees are available on many specified single-ply systems, and they often depend on a registered build-up, an inspection and sometimes an approved installer. Where the system allows, we complete that registration on your behalf. On every re-roof you also receive our written workmanship guarantee, with the length set out in the quote, and you can ask about insurance-backed options. See the guarantees guide and maintenance guide for more.

What insulation and approvals does a single-ply re-roof need?

On a heated building, a full single-ply re-roof usually triggers the thermal-element rules, so insulation should be brought towards the renovation standard where feasible. In England that is 0.18 W/m²K for non-domestic and 0.16 W/m²K for domestic roofs, with Wales and Northern Ireland setting their own figures; Scottish roofs follow Section 6 of the building standards, and the council confirms whether a building warrant is required.

Single-ply suits a warm roof well, and tapered insulation can correct poor falls at the same time. A thicker build-up raises the roof, so we check upstand heights, door thresholds and rooflight kerbs at survey. Near boundaries, the external fire classification of the tested build-up can matter. We handle building control or building standards where needed; see the building regulations page.

Which towns in Berkshire do we cover?

Single-ply membrane roofing in Berkshire: questions

Which towns in Berkshire do you cover?

All of Berkshire. The main towns have their own pages below, and if yours isn't listed we still cover it: send your postcode and we'll confirm.

How much does a single-ply roof cost in Berkshire?

£14,550–£23,950 for a 100 m² commercial roof in single-ply with insulation, at South East guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.

Which postcode areas do you cover in Berkshire?

All of Berkshire, including the GU, RG, SL postcode areas. Send your full postcode and we'll confirm.

Can single-ply be used on a house?

Yes. It can be used on garages, extensions and dormers, usually adhered rather than mechanically fixed. On small domestic roofs, though, EPDM or GRP is often more economical.

Can a single-ply roof be repaired?

Yes. A compatible patch is cleaned and hot-air welded over the damage. Older membranes may need extra cleaning before they weld properly, which the team checks on site.

Is single-ply roofing noisy in the rain?

No more than other flat roofs. Noise depends far more on the deck and insulation than on the membrane, and an insulated warm roof dampens rain noise well.

Everything about single-ply membrane roofing → · All flat roofing in Berkshire →

Get a fixed price for your flat roof

Free survey and a written fixed quote for replacement and new roofs. No obligation.

Call usGet a guide price