Barry at a glance
- Postcode districts
- CF62, CF63
- Population
- about 54,673 (GeoNames)
- Council area
- Vale of Glamorgan Council
- Building approval
- Vale of Glamorgan Council building control, or a registered building control approver
- Nearest main town
- Cardiff, about 7 miles
- Guide price region
- Wales (−8% on West Midlands rates)
Why choose single-ply roofing in Barry?
If a flat roof in Barry has poor falls and ponding, a single-ply re-roof with tapered insulation can correct both problems at once. The tapered boards build the fall into the insulation, and the membrane is laid over the top, with outlets set at the new low points.
In a large town like Barry, flat roofs are commonly found on shops with flat-roofed rear stores below flats or low-rise post-war blocks of flats. Wales averages roughly 1,460 mm of rain a year, among the wettest in Britain, so we design for steady run-off: proper falls, clear outlets and upstands well above the finished roof.
How much does a single-ply roof cost in Barry?
At Wales guide rates, a 100 m² commercial roof in single-ply with insulation comes to £12,150–£20,050 including VAT. The fixed price comes after a free survey for new and replacement roofs.
| Job | Guide price inc VAT |
|---|---|
| Commercial roof (100 m²), single-ply + insulation | £12,150–£20,050 |
| Single garage (18 m²), single-ply | £1,900–£3,050 |
| Single garage (18 m²), EPDM rubber | £1,450–£2,600 |
| Extension (20 m²), EPDM, new deck + insulation | £2,600–£4,500 |
Is single-ply the right system for my roof?
Single-ply is usually the right system for medium and large flat roofs, such as shops, offices, units, surgeries, clubs and blocks, where speed of installation, light weight and long life matter. On a small domestic roof it can work well, though it is not always the most economical choice.
In its favour: lightweight; quick to lay over large areas; flame-free, as the seams are welded with hot air; long typical life; welded details at rooflights and plant; lighter-coloured membranes reflect more sunlight.
Against it: only one waterproof layer, so welding quality is critical; can be punctured by foot traffic or dropped tools without walkway protection; PVC needs separating from bitumen; repairs need compatible material and welding equipment.
For a small garage or extension, EPDM is often simpler. Where people walk regularly, GRP or a liquid system may be tougher. A multi-layer torch-on felt roof gives built-in redundancy, and on older buildings mastic asphalt may be the original material. Our commercial flat roofing page covers larger jobs.
What's included?
- Welded details at upstands, outlets, rooflight kerbs and edge trims
- PVC, TPO or FPO membrane, mechanically fixed, adhered or ballasted
- Hot-air welded seams, each probed along its full length
- Edge protection on every job and walkway protection around plant
Building regulations in Wales
The Welsh Approved Document L applies. Renovating more than half of a roof over a heated room means upgrading it to around 0.16 W/m²K where feasible, and new extension roofs are built to 0.13 W/m²K. Welsh Government guidance is that most re-roofing needs building control approval, so check whenever more than a quarter of a roof is replaced or repaired. We deal with the application as part of the job. More on the rules.
Which nearby areas do we also cover?
- Dinas Powys · 4 mi
- Penarth · 5 mi
- Cardiff · 7 mi
- Whitchurch · 8 mi
- Llantwit Major · 9 mi
- Llantrisant · 10 mi
Single-ply membrane roofing in Barry: questions
Do you cover Barry?
Yes. Barry is part of our Vale of Glamorgan coverage, including postcode districts CF62, CF63. Surveys and roofs are carried out by vetted roofing teams working under S&K Property Investments and Improvement Ltd.
Who checks building regulations for a flat roof in Barry?
Where the work needs approval it goes to Vale of Glamorgan Council building control, or a registered building control approver. We tell you at the survey whether your job needs it and deal with the paperwork as part of the quote.
How much does a single-ply roof cost in Barry?
£12,150–£20,050 for a 100 m² commercial roof in single-ply with insulation, at Wales guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.
Is single-ply roofing noisy in the rain?
No more than other flat roofs. Noise depends far more on the deck and insulation than on the membrane, and an insulated warm roof dampens rain noise well.
Can single-ply roofing be laid over an existing roof?
Sometimes, if the existing roof and deck are dry and sound, often with a separation layer or new insulation on top. Wet insulation or a damaged deck means stripping first.