Llantwit Major at a glance
- Postcode districts
- CF61
- Population
- about 14,384 (GeoNames)
- Council area
- Vale of Glamorgan Council
- Building approval
- Vale of Glamorgan Council building control, or a registered building control approver
- Nearest main town
- Bridgend, about 8 miles
- Guide price region
- Wales (−8% on West Midlands rates)
Why choose single-ply roofing in Llantwit Major?
Single-ply also works on an extension or garage in Llantwit Major if you want a light, clean finish in a pale colour. On small roofs it is usually adhered, and while it can cost more than EPDM, it gives the same welded seams and details found on commercial roofs.
Llantwit Major's flat roofs are mostly on bungalows with flat-roofed side extensions and dormers, with plenty on 1930s semis with flat-roofed garages and kitchen extensions too. Wales averages roughly 1,460 mm of rain a year, among the wettest in Britain, so we design for steady run-off: proper falls, clear outlets and upstands well above the finished roof.
How much does a single-ply roof cost in Llantwit Major?
For Llantwit Major we use Wales rates: £12,150–£20,050 is the guide for a 100 m² commercial roof in single-ply with insulation, VAT included. The fixed price comes after a free survey for new and replacement roofs.
| Job | Guide price inc VAT |
|---|---|
| Commercial roof (100 m²), single-ply + insulation | £12,150–£20,050 |
| Single garage (18 m²), single-ply | £1,900–£3,050 |
| Single garage (18 m²), EPDM rubber | £1,450–£2,600 |
| Extension (20 m²), EPDM, new deck + insulation | £2,600–£4,500 |
How long does a single-ply roof last, and what guarantee comes with it?
A well-installed single-ply roof typically lasts 25 to 35 years or more. Its life depends mostly on the quality of the welds, the fixing pattern, protection from foot traffic and keeping outlets clear.
Signs of trouble on an older single-ply roof include seams lifting at the edges, shrinkage pulling at upstands and corners, punctures near plant, and loose fixings under the membrane on windy sites.
Manufacturer guarantees are available on many specified single-ply systems, and they often depend on a registered build-up, an inspection and sometimes an approved installer. Where the system allows, we complete that registration on your behalf. On every re-roof you also receive our written workmanship guarantee, with the length set out in the quote, and you can ask about insurance-backed options. See the guarantees guide and maintenance guide for more.
What's included?
- Hot-air welded seams, each probed along its full length
- PVC, TPO or FPO membrane, mechanically fixed, adhered or ballasted
- Welded details at upstands, outlets, rooflight kerbs and edge trims
- Vapour control layer and warm-roof or tapered insulation as specified
Building regulations in Wales
The Welsh Approved Document L applies. Renovating more than half of a roof over a heated room means upgrading it to around 0.16 W/m²K where feasible, and new extension roofs are built to 0.13 W/m²K. Welsh Government guidance is that most re-roofing needs building control approval, so check whenever more than a quarter of a roof is replaced or repaired. We deal with the application as part of the job. More on the rules.
Which nearby areas do we also cover?
Single-ply membrane roofing in Llantwit Major: questions
Do you cover Llantwit Major?
Yes. Llantwit Major is part of our Vale of Glamorgan coverage, including postcode districts CF61. Surveys and roofs are carried out by vetted roofing teams working under S&K Property Investments and Improvement Ltd.
Who checks building regulations for a flat roof in Llantwit Major?
Where the work needs approval it goes to Vale of Glamorgan Council building control, or a registered building control approver. We tell you at the survey whether your job needs it and deal with the paperwork as part of the quote.
How much does a single-ply roof cost in Llantwit Major?
£12,150–£20,050 for a 100 m² commercial roof in single-ply with insulation, at Wales guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.
What is the difference between PVC and TPO roofing?
Both are thermoplastic single-ply membranes welded with hot air. PVC contains plasticisers and usually needs separating from bitumen, while TPO and FPO are polyolefin-based; the right one depends on the roof and the system specified.
Can single-ply roofing be laid over an existing roof?
Sometimes, if the existing roof and deck are dry and sound, often with a separation layer or new insulation on top. Wet insulation or a damaged deck means stripping first.