Flat RoofingContractors

Flat roof systems

Torch-on felt roofing in Blackwood

Replacing an old felt roof in Blackwood? Modern torch-on systems are far tougher than the felt many people remember. We strip the existing covering, repair the deck, add warm-roof insulation where needed and lay new membranes with staggered laps. Guide prices are online, and the fixed price comes after our free survey.

Roofer torching a slate-grey mineral cap sheet on a commercial flat roof behind edge protectionComputer-generated example image

Blackwood at a glance

Postcode districts
NP12
Population
about 15,476 (GeoNames)
Council area
Caerphilly County Borough Council
Building approval
Caerphilly County Borough Council building control, or a registered building control approver
Nearest main town
Caerphilly, about 6 miles
Guide price region
Wales (−8% on West Midlands rates)

Why choose torch-on felt roofing in Blackwood?

Where a flat roof in Blackwood already has a felt covering and the building owner wants like-for-like, torch-on is the natural replacement. The old roof is stripped, the deck checked and the new layers laid, often with warm-roof insulation added when the space below is heated.

In a town like Blackwood, flat roofs are commonly found on bungalows with flat-roofed side extensions and dormers or terraced streets with flat-roofed rear kitchens and bathrooms. Wales averages roughly 1,460 mm of rain a year, among the wettest in Britain, so we design for steady run-off: proper falls, clear outlets and upstands well above the finished roof.

How much does a torch-on felt roof cost in Blackwood?

At Wales guide rates, a typical 18 m² garage roof in torch-on felt comes to £1,400–£2,400 including VAT. The fixed price comes after a free survey for new and replacement roofs.

JobGuide price inc VAT
Single garage (18 m²), torch-on felt£1,400–£2,400
Extension (20 m²), felt, new deck + insulation£2,500–£4,300
Block of flats (150 m²), felt + insulation + scaffold£14,300–£25,000
Single garage (18 m²), EPDM rubber£1,450–£2,600
Extension (20 m²), EPDM, new deck + insulation£2,600–£4,500

Should I choose torch-on felt or a different flat roof system?

Choose torch-on felt when you want a proven, layered system at a sensible price, particularly on larger roofs, blocks of flats and commercial buildings where several layers give useful redundancy. It is a weaker choice where hot works are hard to manage safely.

For: generally lower cost per square metre; two or three layers, so a single defect in one layer need not cause a leak; tough mineral finish; long track record and a British Standard code of practice; repairs can be made with compatible materials.

Against: needs a naked flame unless a cold-applied or self-adhesive alternative is used; shorter typical life than EPDM or GRP; the finish is functional rather than decorative; more laps to detail than a single sheet.

On small domestic roofs near timber, EPDM avoids the torch entirely. GRP gives a harder, neater surface. For an overlay, a liquid-applied system is often simpler. Large commercial roofs may suit single-ply, and older buildings may suit mastic asphalt. See our comparison guide.

What's included?

  • Hot-works checks and fire watch on every torch-on job
  • Two- or three-layer reinforced bitumen membrane with staggered laps
  • Strip-off of the existing roof covering and removal of waste
  • Vapour control layer and warm-roof insulation where needed

Building regulations in Wales

The Welsh Approved Document L applies. Renovating more than half of a roof over a heated room means upgrading it to around 0.16 W/m²K where feasible, and new extension roofs are built to 0.13 W/m²K. Welsh Government guidance is that most re-roofing needs building control approval, so check whenever more than a quarter of a roof is replaced or repaired. We deal with the application as part of the job. More on the rules.

Which nearby areas do we also cover?

Torch-on felt roofing in Blackwood: questions

Do you cover Blackwood?

Yes. Blackwood is part of our Caerphilly coverage, including postcode districts NP12. Surveys and roofs are carried out by vetted roofing teams working under S&K Property Investments and Improvement Ltd.

Who checks building regulations for a flat roof in Blackwood?

Where the work needs approval it goes to Caerphilly County Borough Council building control, or a registered building control approver. We tell you at the survey whether your job needs it and deal with the paperwork as part of the quote.

How much does a torch-on felt roof cost in Blackwood?

£1,400–£2,400 for a typical 18 m² garage roof in torch-on felt, at Wales guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.

Is torch-on felt better than the old felt roofs?

Yes, considerably. Modern torch-on membranes are polymer-modified and polyester-reinforced, laid in bonded layers, and typically last much longer than the older felt systems they replace.

Can torch-on felt be laid in wet weather?

Not in rain or on a wet deck, because moisture trapped under the membrane causes blisters. Light cold weather is usually workable, but we will postpone rather than lay on a damp surface.

Other flat roof work in Blackwood

Torch-on felt roofing in Blackwood: get a fixed price

Free survey and a written fixed quote for replacement and new roofs. No obligation.

Call usGet a guide price