Gelligaer at a glance
- Postcode districts
- CF82
- Population
- about 17,376 (GeoNames)
- Council area
- Caerphilly County Borough Council
- Building approval
- Caerphilly County Borough Council building control, or a registered building control approver
- Nearest main town
- Caerphilly, about 6 miles
- Guide price region
- Wales (−8% on West Midlands rates)
Why choose torch-on felt roofing in Gelligaer?
Torch-on is a good fit in Gelligaer when the budget matters but quality cannot slip. Modern polyester-reinforced membranes typically last 15 to 25 years, high-performance systems longer, and manufacturer material guarantees are available on many specified systems, registered where the system allows.
In a town like Gelligaer, flat roofs are commonly found on newer estates where the first extension roofs are now being replaced or 1930s semis with flat-roofed garages and kitchen extensions. Wales averages roughly 1,460 mm of rain a year, among the wettest in Britain, so we design for steady run-off: proper falls, clear outlets and upstands well above the finished roof.
How much does a torch-on felt roof cost in Gelligaer?
For Gelligaer we use Wales rates: £1,400–£2,400 is the guide for a typical 18 m² garage roof in torch-on felt, VAT included. The fixed price comes after a free survey for new and replacement roofs.
| Job | Guide price inc VAT |
|---|---|
| Single garage (18 m²), torch-on felt | £1,400–£2,400 |
| Extension (20 m²), felt, new deck + insulation | £2,500–£4,300 |
| Block of flats (150 m²), felt + insulation + scaffold | £14,300–£25,000 |
| Single garage (18 m²), EPDM rubber | £1,450–£2,600 |
| Extension (20 m²), EPDM, new deck + insulation | £2,600–£4,500 |
Does replacing a felt roof mean upgrading the insulation?
Usually, yes, when the roof is over a heated space and more than half of it is being re-covered. In England, Wales and Northern Ireland that is renovation of a thermal element, which should be brought towards the renovation U-value where feasible; a Scottish project goes through the council's building standards service, which confirms whether a warrant applies.
A felt replacement is a good point to switch to a warm roof, with insulation laid above the deck under the new membranes. On larger roofs, tapered insulation can also correct poor falls that have caused ponding, which a patch repair cannot fix. Raising the roof level affects upstands and door thresholds, so we check heights at survey. Any approval is arranged by us as part of the job, and the building regulations page sets out the rules by nation.
What's included?
- Two- or three-layer reinforced bitumen membrane with staggered laps
- Deck inspection with replacement of damaged boards
- Vapour control layer and warm-roof insulation where needed
- Mineral-finished cap sheet, upstands, outlets and edge trims
Building regulations in Wales
The Welsh Approved Document L applies. Renovating more than half of a roof over a heated room means upgrading it to around 0.16 W/m²K where feasible, and new extension roofs are built to 0.13 W/m²K. Welsh Government guidance is that most re-roofing needs building control approval, so check whenever more than a quarter of a roof is replaced or repaired. We deal with the application as part of the job. More on the rules.
Which nearby areas do we also cover?
Torch-on felt roofing in Gelligaer: questions
Do you cover Gelligaer?
Yes. Gelligaer is part of our Caerphilly coverage, including postcode districts CF82. Surveys and roofs are carried out by vetted roofing teams working under S&K Property Investments and Improvement Ltd.
Who checks building regulations for a flat roof in Gelligaer?
Where the work needs approval it goes to Caerphilly County Borough Council building control, or a registered building control approver. We tell you at the survey whether your job needs it and deal with the paperwork as part of the quote.
How much does a torch-on felt roof cost in Gelligaer?
£1,400–£2,400 for a typical 18 m² garage roof in torch-on felt, at Wales guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.
Is torch-on suitable for a block of flats?
Yes, layered bitumen systems are widely used on blocks of flats and commercial buildings. Larger roofs often use three layers and insulation, with hot works planned around residents.
Is torch-on felt better than the old felt roofs?
Yes, considerably. Modern torch-on membranes are polymer-modified and polyester-reinforced, laid in bonded layers, and typically last much longer than the older felt systems they replace.