Flat RoofingContractors

Flat roof systems

Torch-on felt roofing in Ely

For blocks of flats, shops and houses in Ely, torch-on felt remains a practical way to re-roof at a sensible cost. Each job follows the same pattern: survey, written quote, strip and lay, then a fire watch and a walk-round with you before we hand over the written workmanship guarantee.

Roofer torching a slate-grey mineral cap sheet on a commercial flat roof behind edge protectionComputer-generated example image

Ely at a glance

Postcode districts
CB7
Population
about 20,574 (GeoNames)
Council area
East Cambridgeshire District Council
Building approval
East Cambridgeshire District Council building control, or a registered building control approver
Nearest main town
Cambridge, about 15 miles
Guide price region
East of England (+5% on West Midlands rates)

Why choose torch-on felt roofing in Ely?

Where a flat roof in Ely already has a felt covering and the building owner wants like-for-like, torch-on is the natural replacement. The old roof is stripped, the deck checked and the new layers laid, often with warm-roof insulation added when the space below is heated.

In and around Ely, flat roofs are typically found on bungalows with flat-roofed side extensions and dormers, and on low-rise post-war blocks of flats. The East of England is the driest part of Britain, with parts of the Anglian region around 630 mm a year, so summer heat and UV, not rainfall, do most of the ageing on a felt roof.

How much does a torch-on felt roof cost in Ely?

At East of England guide rates, a typical 18 m² garage roof in torch-on felt comes to £1,600–£2,750 including VAT. The fixed price comes after a free survey for new and replacement roofs.

JobGuide price inc VAT
Single garage (18 m²), torch-on felt£1,600–£2,750
Extension (20 m²), felt, new deck + insulation£2,850–£4,900
Block of flats (150 m²), felt + insulation + scaffold£16,350–£28,550
Single garage (18 m²), EPDM rubber£1,700–£2,950
Extension (20 m²), EPDM, new deck + insulation£2,950–£5,150

Is torch-on roofing safe, and what is the difference between two- and three-layer systems?

Yes, torch-on is safe when hot works are properly controlled, because most roof fires linked to torching start at hidden timber or debris near edges and upstands, not on the open roof. Our teams follow a hot-works routine on every job:

  • check eaves, fascias, soffits and wall cavities for timber, nests and debris before lighting a torch;
  • use a cold-applied or self-adhesive membrane, rather than a flame, at edges, against combustible materials and in tight details;
  • keep fire extinguishers on the roof and the gas bottles secured and away from the work;
  • stop torching well before the team leaves, then carry out a fire watch so smouldering is spotted while people are still on site.

As for layers, a two-layer system (underlay plus cap sheet) is common on domestic roofs such as garages and extensions. A three-layer system adds an intermediate sheet, giving more thickness and redundancy, and is often specified on larger, commercial and multi-occupied roofs. The right choice depends on the size and use of the roof and the system's requirements, so we set it out in the quote.

Near a boundary, the external fire performance of the tested build-up, such as a BROOF(t4) classification, can also matter, and we check it where it applies.

What's included?

  • Deck inspection with replacement of damaged boards
  • Mineral-finished cap sheet, upstands, outlets and edge trims
  • Strip-off of the existing roof covering and removal of waste
  • Two- or three-layer reinforced bitumen membrane with staggered laps

Building regulations in England

Replacing more than half of a flat roof over a heated room usually counts as renovating a thermal element, so the roof is insulated to around 0.16 W/m²K where that's technically and economically feasible, and the work is notified to building control: the council or a registered building control approver, unless a registered competent person self-certifies it. A roof on a new extension is built to 0.15 W/m²K. Patch repairs, and most unheated detached garages, don't trigger the upgrade. Structural changes, or a new covering that adds 15% or more to the roof's weight, also need approval. More on the rules.

Which nearby areas do we also cover?

Torch-on felt roofing in Ely: questions

Do you cover Ely?

Yes. Ely is part of our Cambridgeshire coverage, including postcode districts CB7. Surveys and roofs are carried out by vetted roofing teams working under S&K Property Investments and Improvement Ltd.

Who checks building regulations for a flat roof in Ely?

Where the work needs approval it goes to East Cambridgeshire District Council building control, or a registered building control approver. We tell you at the survey whether your job needs it and deal with the paperwork as part of the quote.

How much does a torch-on felt roof cost in Ely?

£1,600–£2,750 for a typical 18 m² garage roof in torch-on felt, at East of England guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.

Can I paint or coat an old felt roof?

Reflective or liquid coatings can extend the life of a sound felt roof, but they will not fix wet insulation, a rotten deck or poor falls. A survey shows whether coating or replacement makes more sense.

How long does it take to lay a torch-on felt roof?

A garage roof typically takes one to two days and an insulated extension two to three. Larger roofs and blocks are phased over longer, with each area made weathertight before the team leaves.

Other flat roof work in Ely

Torch-on felt roofing in Ely: get a fixed price

Free survey and a written fixed quote for replacement and new roofs. No obligation.

Call usGet a guide price