Mold at a glance
- Postcode districts
- CH7
- Population
- about 10,058 (GeoNames)
- Council area
- Flintshire County Council
- Building approval
- Flintshire County Council building control, or a registered building control approver
- Nearest main town
- Buckley, about 2 miles
- Guide price region
- Wales (−8% on West Midlands rates)
What does a balcony or terrace in Mold need?
Settled, rocking or cracked paving is a common reason to re-waterproof a terrace in Mold. Slabs bedded directly on the membrane can damage it over time. Relaying them on adjustable pedestals protects the waterproofing and gives a level surface that drains underneath.
In and around Mold, flat roofs are typically found on low-rise post-war blocks of flats, and on bungalows with flat-roofed side extensions and dormers. Wales averages roughly 1,460 mm of rain a year, among the wettest in Britain, so we design for steady run-off: proper falls, clear outlets and upstands well above the finished roof.
How much does balcony or terrace waterproofing cost in Mold?
Guide price in Mold: £1,750–£3,000 for a 12 m² balcony in a liquid-applied system including scaffold, including VAT at Wales rates. The fixed price comes after a free survey for new and replacement roofs.
| Job | Guide price inc VAT |
|---|---|
| Balcony (12 m²), liquid-applied, scaffold | £1,750–£3,000 |
| Single garage (18 m²), EPDM rubber | £1,450–£2,600 |
| Extension (20 m²), GRP, new deck + insulation | £2,750–£4,950 |
Do I need planning permission for a balcony or roof terrace?
For a new balcony or roof terrace, generally yes. In England, balconies and raised platforms are not permitted development for houses, so a planning application is normally needed, and the other nations have their own rules.
Re-waterproofing an existing, approved balcony that looks the same afterwards does not normally need planning. Building regulations are a separate question. A terrace over a heated room is a thermal element, so replacing most of it can bring insulation requirements and approval. Turning a flat roof into a terrace also raises structural questions, because people, furniture and paving add load, and it needs guarding, such as a balustrade, that meets the regulations. A structural engineer should confirm that the roof can carry the new use.
Listed buildings and conservation areas add another layer of control. Our building regulations page covers approvals, and our planning permission guide covers the planning side.
What's included?
- Lifting and setting aside of existing paving or decking
- Written workmanship guarantee, with approvals handled where needed
- New liquid, GRP, single-ply or asphalt waterproofing
- Sealed details at doors, outlets, walls and balustrade posts
Building regulations in Wales
The Welsh Approved Document L applies. Renovating more than half of a roof over a heated room means upgrading it to around 0.16 W/m²K where feasible, and new extension roofs are built to 0.13 W/m²K. Welsh Government guidance is that most re-roofing needs building control approval, so check whenever more than a quarter of a roof is replaced or repaired. We deal with the application as part of the job. More on the rules.
Which nearby areas do we also cover?
Balconies and roof terraces in Mold: questions
Do you cover Mold?
Yes. Mold is part of our Flintshire coverage, including postcode districts CH7. Surveys and roofs are carried out by vetted roofing teams working under S&K Property Investments and Improvement Ltd.
Who checks building regulations for a flat roof in Mold?
Where the work needs approval it goes to Flintshire County Council building control, or a registered building control approver. We tell you at the survey whether your job needs it and deal with the paperwork as part of the quote.
How much does balcony or terrace waterproofing cost in Mold?
£1,750–£3,000 for a 12 m² balcony in a liquid-applied system including scaffold, at Wales guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.
What is an inverted roof terrace?
It is a terrace where the insulation sits above the waterproofing, held down by paving or ballast. The membrane stays protected and at a steadier temperature.
Can I put decking straight onto my flat roof?
Not directly onto the membrane. Decking needs a supporting system that spreads the load and lets water drain, and the roof must be checked for the extra weight.