- Guide price
- £14,550–£23,950
- Survey
- Free for new and replacement roofs
- Quote
- Fixed, in writing
- Coverage
- England, Wales, Scotland, NI
Hampshire at a glance
- Largest towns
- Southampton, Portsmouth, Basingstoke, Gosport
- Postcode areas
- BH, GU, PO, RG, SO, SP
- Building control
- Southampton City Council, Portsmouth City Council, Basingstoke and Deane Borough Council and 10 other councils
- Neighbouring areas
- Isle of Wight · Berkshire · West Sussex · Surrey
- Guide price region
- South East (+10% on West Midlands rates)
How much does a commercial flat roof cost in Hampshire?
Guide prices including VAT at South East rates. The fixed price comes after a free survey for new and replacement roofs.
| Job | Guide price inc VAT |
|---|---|
| Commercial roof (100 m²), single-ply + insulation | £14,550–£23,950 |
| Condition survey and leak investigation | £170–£330 |
| Block of flats (150 m²), felt + insulation + scaffold | £17,100–£29,900 |
Which flat roofs are common in Hampshire?
Flat roofs in Hampshire sit on 1930s semis with flat-roofed garages and kitchen extensions, shops with flat-roofed rear stores below flats and 1960s and 1970s link-detached houses with flat-roofed garages and porches. Much of the South East sits in the drier Thames catchment at roughly 730 mm of rain a year, so the usual failures are at joints, upstands and outlets rather than from sheer volume of rain. Approximate 1991–2020 regional averages based on Met Office data.
Building regulations in England
Replacing more than half of a roof over a heated room usually counts as renovating a thermal element, so it is insulated to current standards and notified to building control. Renovated roofs over heated rooms are insulated to around 0.16 W/m²K where that's feasible, and new extension roofs are built to 0.15 W/m²K. In Hampshire the application goes to Southampton City Council, Portsmouth City Council, Basingstoke and Deane Borough Council and 10 other councils. More on the rules.
How do you handle CDM, roof access and fragile surfaces?
Every job is planned under the Construction (Design and Management) Regulations 2015, or CDM (NI) 2016 in Northern Ireland, with a construction phase plan and a method statement for the roof.
As a commercial client you have duties under CDM too, including passing on information about the building, such as drawings, details of previous roof work and the asbestos register. Buildings put up before 2000 can contain asbestos, so we ask for the register or a refurbishment survey before pricing a strip-out. If asbestos is found, a licensed specialist surveys and removes it before we start.
Roofs and rooflights are treated as fragile until a competent person confirms otherwise. Edge protection goes up on every job, rooflights and fragile sheets are covered or fenced off, and we agree safe access before work starts: scaffold, a tower, a powered access platform or a fixed access point where one is suitable.
Which roofing system suits a commercial flat roof?
Single-ply membrane usually suits large, simple roofs; built-up felt suits roofs with heavy foot traffic, plant or complex detailing; and a liquid-applied overlay suits a sound roof that needs new waterproofing without a full strip-out.
- Single-ply (PVC, TPO or FPO): light and quick to lay over large areas, with hot-air welded laps and fixing or bonding designed for the site's wind uplift. Indicative life 25–35+ years. See single-ply roofing.
- Built-up felt: two or three layers of reinforced bitumen membrane laid to BS 8217, hard-wearing around plant and maintenance routes. Modern systems last 15–25 years, high-performance systems longer. See torch-on felt roofing.
- Liquid-applied overlay: a reinforced coating that cures to one continuous layer, well suited to pipework, plant bases and awkward details. Indicative life 10–25+ years depending on the product. See liquid roofing.
Mastic asphalt suits concrete decks and walkways, and EPDM suits simpler roofs with few penetrations. An overlay only works where the existing roof is dry and firmly bonded, so we check for wet insulation before recommending one (see overlay or strip).
Which towns in Hampshire do we cover?
- Southampton
- Portsmouth
- Basingstoke
- Gosport
- Waterlooville
- Farnborough
- Eastleigh
- Winchester
- Havant
- Andover
- Fareham
- Aldershot
- Fleet
- Totton
- New Milton
- Bordon
- Hythe
- Yateley
- Alton
- Emsworth
- Hedge End
- Romsey
- Hayling Island
- Tadley
Commercial flat roofing in Hampshire: questions
Which towns in Hampshire do you cover?
All of Hampshire. The main towns have their own pages below, and if yours isn't listed we still cover it: send your postcode and we'll confirm.
How much does a commercial flat roof cost in Hampshire?
£14,550–£23,950 for a 100 m² commercial roof in single-ply with insulation, at South East guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.
Which postcode areas do you cover in Hampshire?
All of Hampshire, including the BH, GU, PO, RG, SO, SP postcode areas. Send your full postcode and we'll confirm.
Can you re-roof while our premises stay open?
Usually, yes. We phase the work so each section is watertight before the team leaves site, keep entrances and fire exits clear, and agree working hours and deliveries with you first.
Do you need a hot works permit?
Only if torch-on felt or other naked-flame work is used, in which case the team works under your permit system with a fire watch afterwards. Where hot works are not allowed, we specify a flame-free system such as a cold-applied membrane.
Can our existing roof be overlaid instead of stripped?
Often, if the survey shows the existing covering is sound, dry and firmly bonded. Wet insulation, a soft deck or several old layers mean a strip-out is the better long-term answer.
Everything about commercial flat roofing → · All flat roofing in Hampshire →