- Guide price
- £120–£360
- Repair price
- Confirmed once the leak or damage is found
- Condition survey report
- £150–£310
- Coverage
- England, Wales, Scotland, NI
Bristol at a glance
- Largest towns
- Bristol
- Postcode areas
- BS
- Building control
- Bristol City Council
- Neighbouring areas
- Somerset · Gloucestershire · Wiltshire · Herefordshire
- Guide price region
- South West (+3% on West Midlands rates)
How much does a new roof edge or outlet cost in Bristol?
Guide prices including VAT at South West rates. We confirm the price once we've traced the leak or seen the damage.
| Job | Guide price inc VAT |
|---|---|
| Outlet or drainage repair | £120–£360 |
| Localised patch repair | £150–£520 |
| Upstand or flashing repair | £260–£670 |
| Emergency temporary weatherproofing visit | £190–£460 |
| Condition survey and leak investigation | £150–£310 |
Which flat roofs are common in Bristol?
Flat roofs in Bristol sit on shops with flat-roofed rear stores below flats, newer estates where the first extension roofs are now being replaced and 1960s and 1970s link-detached houses with flat-roofed garages and porches. The South West averages roughly 1,260 mm of rain a year and many roofs face wind off the Atlantic, so we specify fixings and edge details for wind uplift as well as drainage. Approximate 1991–2020 regional averages based on Met Office data.
Building regulations in England
Replacing more than half of a roof over a heated room usually counts as renovating a thermal element, so it is insulated to current standards and notified to building control. Renovated roofs over heated rooms are insulated to around 0.16 W/m²K where that's feasible, and new extension roofs are built to 0.15 W/m²K. In Bristol the application goes to Bristol City Council. More on the rules.
Should I fix the edges and drainage or replace the whole roof?
Fix the edges and drainage on their own if the covering is in good condition and the deck is sound. If the covering is near the end of its life or the falls need correcting across the whole roof, it is usually better value to do everything together as part of a replacement.
Trims and outlets are bonded into the waterproofing, so replacing them means cutting into the covering around the edge. On a roof with plenty of life left, that is a worthwhile repair. On an old, brittle covering, the new detail can end up stronger than the roof around it, and correcting falls means taking the covering off anyway. Our repair or replace guide sets out how to decide.
How long do flat roof trims and outlets last?
Properly fixed GRP or aluminium trims and well-installed outlets should last about as long as the waterproofing they are part of. What shortens their life is poor fixing, movement in a rotten deck edge and blockages that are never cleared.
A quick check of outlets and gutters each autumn, and again after storms, prevents most drainage problems. Look for leaves and silt in outlets, gutters pulling away from the fascia, trims that have lifted or split at joints and staining on the wall below the edge. The maintenance guide lists what to check and when. Only check what you can see safely from the ground, a window or a ladder at the edge, and never walk on a roof that isn't designed for it.
Which towns in Bristol do we cover?
Edge trims, outlets and drainage in Bristol: questions
Which towns in Bristol do you cover?
All of Bristol. The main towns have their own pages below, and if yours isn't listed we still cover it: send your postcode and we'll confirm.
How much does a new roof edge or outlet cost in Bristol?
£120–£360 for an outlet or drainage repair, at South West guide rates including VAT. We confirm the price once we've traced the leak or seen the damage.
Which postcode areas do you cover in Bristol?
All of Bristol, including the BS postcode areas. Send your full postcode and we'll confirm.
What's the difference between a drip trim and an edge trim?
An edge trim finishes the edge of the roof and holds the waterproofing down. A drip trim has a profile that throws water clear into the gutter. On many roofs a single trim does both jobs.
Do new trims need building regulations approval?
Not usually on their own. Approval only becomes a question if the work is part of a larger re-roofing job or alters the structure.
Why is my fascia rotting under a flat roof?
Usually because water is getting behind a loose or badly lapped trim, or running back under the edge because there is no proper drip. The fascia and deck edge are replaced and new trims are fitted to stop it happening again.
Everything about edge trims, outlets and drainage → · All flat roofing in Bristol →