Pembroke Dock at a glance
- Postcode districts
- SA72
- Population
- about 9,657 (GeoNames)
- Council area
- Pembrokeshire County Council
- Building approval
- Pembrokeshire County Council building control, or a registered building control approver
- Nearest main town
- Haverfordwest, about 8 miles
- Guide price region
- Wales (−8% on West Midlands rates)
Why choose torch-on felt roofing in Pembroke Dock?
Torch-on felt is widely specified for blocks of flats and HMOs, in Pembroke Dock as elsewhere, because the system is well understood, widely repairable and governed by a British Standard code of practice. Three-layer builds with insulation are common on larger, multi-occupied roofs.
In a town like Pembroke Dock, flat roofs are commonly found on lock-up garage blocks on estates or shops with flat-roofed rear stores below flats. Wales averages roughly 1,460 mm of rain a year, among the wettest in Britain, so we design for steady run-off: proper falls, clear outlets and upstands well above the finished roof.
How much does a torch-on felt roof cost in Pembroke Dock?
At Wales guide rates, a typical 18 m² garage roof in torch-on felt comes to £1,400–£2,400 including VAT. The fixed price comes after a free survey for new and replacement roofs.
| Job | Guide price inc VAT |
|---|---|
| Single garage (18 m²), torch-on felt | £1,400–£2,400 |
| Extension (20 m²), felt, new deck + insulation | £2,500–£4,300 |
| Block of flats (150 m²), felt + insulation + scaffold | £14,300–£25,000 |
| Single garage (18 m²), EPDM rubber | £1,450–£2,600 |
| Extension (20 m²), EPDM, new deck + insulation | £2,600–£4,500 |
How long does a torch-on felt roof last, and what is the guarantee?
A modern torch-on roof typically lasts 15 to 25 years, and high-performance systems with better membranes can last longer. That is a big step up from older felt roofs, which were often single-layer, unreinforced or poorly bonded.
What shortens the life of a felt roof is usually visible: mineral chippings worn away so the bitumen is exposed to sunlight, blisters where moisture was trapped, split laps, and upstands that have slumped or pulled away from the wall. Ponding speeds all of this up.
Manufacturer material guarantees are available on many specified torch-on systems; they often depend on a particular build-up and registration, which we handle where the system allows. Every re-roof also comes with our written workmanship guarantee, the length of which is stated in the quote, and insurance-backed options can be discussed. Our flat roof lifespan guide compares felt with the other systems.
What's included?
- Mineral-finished cap sheet, upstands, outlets and edge trims
- Strip-off of the existing roof covering and removal of waste
- Deck inspection with replacement of damaged boards
- Vapour control layer and warm-roof insulation where needed
Building regulations in Wales
The Welsh Approved Document L applies. Renovating more than half of a roof over a heated room means upgrading it to around 0.16 W/m²K where feasible, and new extension roofs are built to 0.13 W/m²K. Welsh Government guidance is that most re-roofing needs building control approval, so check whenever more than a quarter of a roof is replaced or repaired. We deal with the application as part of the job. More on the rules.
Which nearby areas do we also cover?
Torch-on felt roofing in Pembroke Dock: questions
Do you cover Pembroke Dock?
Yes. Pembroke Dock is part of our Pembrokeshire coverage, including postcode districts SA72. Surveys and roofs are carried out by vetted roofing teams working under S&K Property Investments and Improvement Ltd.
Who checks building regulations for a flat roof in Pembroke Dock?
Where the work needs approval it goes to Pembrokeshire County Council building control, or a registered building control approver. We tell you at the survey whether your job needs it and deal with the paperwork as part of the quote.
How much does a torch-on felt roof cost in Pembroke Dock?
£1,400–£2,400 for a typical 18 m² garage roof in torch-on felt, at Wales guide rates including VAT. The fixed price comes after a free survey for new and replacement roofs.
Can torch-on felt go over an existing felt roof?
Sometimes, if the old roof is dry, well bonded and the deck is sound. Often stripping is better, because overlaying can trap moisture and hide rot; our guide to overlay or strip explains how we decide.
Is torch-on suitable for a block of flats?
Yes, layered bitumen systems are widely used on blocks of flats and commercial buildings. Larger roofs often use three layers and insulation, with hot works planned around residents.